2012/8/29 18:34:33
Mineral crushing materials for the machine is suitable for crushing various brittle materials such as coal, gypsum, alum, brick, limestone. The compressive strength of its material is not a force of more than 1000 kg / cm 2, humidity less than 2%Crusher structure outlined
This crusher machine is mainly a combination by the rack, a rotor, a sieve, Zhong such parts, components, motors directly drive the rotor through the flexible coupling, the knock-on effect of the material arising due to rotation of the rotor when the hammer bit on the material and crushing.
The two parts of the the rack points superstructure and Xiazuo inner wall equipped with a protective liner to prevent the rack internal wear, the rack is equipped with four small door located in the wall of the small door shelves, used to adjust the crushing plate the wall of the small door, as clear unbreakable material. Xiazuo front and rear walls of the two small doors is prepared for the use of back and clean up the screen bars.
Rotor by the rotor shaft, triangular plate, disc, hammer axes, hammers and other parts. The rotor shaft equipped with a triangular plate and the disc, the disc and the disc to the sleeve between the spaced, disc equipped with a hammer shaft, the hammer is hanging in the shaft of the hammer, when the rotation of the rotor shaft, a hammer that, as the slewing.
Grizzly bar device the next seat wall on both sides of the screen long shelf tank. Article sieve frame the following equipped with eccentric prepared for the purposes of the gap between the adjust the screening length with hammer.
Stone crusher installation instructions
The crusher machine is assembled by manufacturing plants supply when the user receives the machine should be checked, in order to eliminate the occurrence of the ills in the transport process.
1, the foundation plans supplied by the manufacturer. Only crusher and motor arranged location, users reference the pattern design and installation diagram combined with the actual situation.
2, the machine should be installed on a concrete foundation, should be considered in the design basis of the location of the discharge.
3, in order to reduce the vibration to prevent vibration machine work affects buildings, native and the middle of the concrete foundation should be embedded to the hardwood pad or other mitigation vibration material.
4, when installed, the motor and the rotor shaft center should ensure straight, so as not to affect the elastic sleeve coupling premature damage and cause the bearings with the fever.
5, the transmission part of this machine in the right side of the machine, but its position according to the actual needs and changes.