2012/11/29 18:12:32
Crusher machine will appear in the course of their work, one way or another failure. Will encounter different problems in different areas of use, improper operation or low quality equipment, or environmental factors, but the time will not wait for you, so maintenance but also as early as possible.1, main bearing temperature is too high. Solution: It may be lack of grease, then you need to add the right amount of grease; the grease pollution, needs cleaning bearing replacement grease; bearing damage, then you need to replace the bearings out.
2, the discharge size is too large. Solution: broken tooth wear too much, then you need to replace the broken teeth or surfacing; side tooth wear or loss, on the replacement.
Crusher vibrations increase. Solution: bearing damage, to be replaced; gear coupling is damaged, replace;
4, lower processing power, or lack of motivation. Solution: leakage of fluid coupling, then supplement the quantitative turbine oil No. 22 or No. 6 hydraulic transmission oil, coupler bad you need a new one; uneven feed, and then adjust the feed.
5, can not be automatically reversed. Solutions: sensor installed incorrect or damaged, the whole sand washing machine or replace the sensor tune Henan; sensor leads or wiring loose on the the switched lead or tighten the line at.
6, sensor protection system failure. Solution: proximity switch is damaged or loose wiring inside the control cabinet, then you need to replace the added switch or wired according to the wiring diagram.
To crusher to maintain a good working condition, ready to be put into operation, to reduce the failure rate, improve good rate and the utilization of the stone crusher, to extend the service life of the crusher, then the day-to-day maintenance of the crusher and maintenance is indispensable, not only does not support, and repair dependents.