2016/11/18 1:12:34
The determination of cone crusher maintenance cycle should be set according to the actual status of the equipment.
Minor repair cycle every half a month to a month, its contents include:
(1) check the bowl tile;
(2) check the wear condition of taper sleeve and straight sets and check its clearance.
(3) check the cone gear backlash;
(4) check the drive bearing clearance;
(5) check the hydraulic device (such as the didn't equipped with hydraulic device) or replace lubricating oil and lubrication devices.
(6) the main parts of cleaning.
Long cycle about 4 ~ 6 months time, the main content includes:
(1) the replacement of lining board;
(2) the repair or replacement of eccentric shaft sleeve, taper sleeve and straight sets;
(3) repair or replace the bowl and dust control device;
(4), to repair or replace the cone gear shaft and bearing shell;
(5) repair the adjusting ring and bearing casing thread;
(6) for minor repair project inspection and handling of all;
(7) decomposition motor, blowing dust removal and check each bearing clearance;Decompose oil switch, cleaning and dealing with defects;By electric adjustment and test;Check and repair panel and other cable, etc.
Overhaul for about 4 years or determined according to the actual situation.Its contents include:
(1) repair or replace the frame and the relevant problems of parts;
(2) to repair the project inspection and handling of all, as well as the technical renovation;
(3) the replacement of motor stator coil (determined according to the preventive test) and varnished.According to the actual situation to decide whether to change the rotor shaft.